The Ramsey Model SWAX-7000 Primary Sweep Type Sampler offers an economical and simple means to procure a representative sample directly from material on a conveyor belt. With over 1,000 units in service worldwide, it has been subjected to rigorous in-the-field testing and meets ASTM and ISO specifications.
Product Detail
This sampler can be used as a stand-alone sampling device or as a primary in a multi-stage mechanical sampling system. Direct increments are obtained from in-motion, horizontal or inclined conveyors. It is ideally suited for the sampling of coal, limestone, ferrous and non-ferrous ores, sand, crushed rock and gravel. In high tonnage applications, the cutter is counterbalanced to prevent excessive stress on the conveyor.
Features and Benefits
- Compact design is well-suited for low headroom installations.
- Ease of installation results in modest installation costs.
- Mounts directly to existing or new conveyors. No transfer point is required.
- Rigid construction of tubular structural steel maintains positive alignment.
- Direct drive for positive stopping whether the belt is loaded or empty.
- Skirtboards on sampler prevent material spillage.
- Cost efficient. Small primary increment means smaller, less expensive equipment in the reduction stages of system.
- Non-contact proximity switches for start-stop control.
- Replaceable steel brushes and urethane wiper assure fines will be removed and included in representative sample.
- Samplers counterweighted to eliminate high eccentric loading on 36" and larger belts.
SWAX-7000 Data Sheet (322 Kb)
|
